SINGLE-PHASE OR THREE-PHASE CONTROL PANEL

• Power supply 1phase 100-240Vac 50/60Hz (Mono-phase);
• Power supply 3phase 100-240Vac 50/60Hz (Three-phase);
• Input for 3 single-pole probes (COM-MIN-MAX);
• Input G.A. normally open for alarm activation;
• Push-buttons for selecting operation AUTOMATIC-0-MANUAL (temporary);
• DIP-SWITCH selectors for:
• enabling level alarm from probes;
• thermal cut-out activation delay 5/10 seconds;
• alarm output settings;
• alarm reset enable from motor clicson;
• filling/emptying mode;
• enabling start/stop float function;
• delay of electronic board activation on power mains return.
• Green led: power ON / failure or incorrect phase sequence;
• Red led: level alarm from probes or GA input;
• Electronic control of max current due to overload, with assisted calibration;
• Electronic control of minimum current due to dry run, with assisted calibration;
• Automatic reset due to minimum current alarm;
• Timer for delay of motor enabling on power mains return;
• Protection of auxiliary circuits and motor with fuses;
• Cumulative alarm output with voltage-free contacts (COM-NO-NC resistive load - 5A / 250V);
• Cumulative alarm output, live (12Vcc / 100mA);
• Door lock general disconnect switch;
• Provision for run capacitors, single phase version (not included);
• Box in ABS, IP55;
• Ambient temperature: -5/+40 °C;
• Relative humidity 50% at 40 °C (condensate free).
• G/P1 and G/P2 normally open input;
• T1 and T2 inputs for motor clicson;
• 2 Green leds: automatic mode enabled;
• 2 Green led: motor active;
• 2 Red led: motor overload alarm/ minimum current
• 2 Red led: motor clicson activation alarm
• DIP-SWITCH selector #8 for enabling motors exchange.